Cleaning this machine will also help you avoid a cleaning fee upon return. If you are sanding on a second (or higher) floor or need to haul it up a step or two, you may need a helper for assistance.
Neither the drum nor the large orbital sander will allow you to get all the way up to the intersection of the wall and floor. With this type of tool your technique is not as important, but you still want to sand in the direction of the grain of the wood and you always want the machine moving as it's running. Its benefit is that it can help you level a floor without taking too much wood away.
Large Orbital Sander (good for moderate removal of large areas): This will take some time as you will want to remove the gouge in small steps then remove the dust with a vacuum. If you do gouge the wood, go over it with the sander at a 45° angle to the gouge, keeping the machine in motion at all times.
It will take a large amount of surface off in a very short time. Large Drum Sander (good for rapid removal and large areas): Unless your floor is relatively pristine, you do not want to hand sand it; that will simply take too long.
You can certainly try sanding it away, but you might want to be prepared to replace the plank. This may take a week or two, but what it will do is allow your plank or strip to have the same moisture content as the surrounding floor. Early American flooring came in various widths per board, ranging from a narrow three inches to a wide six inches.
If you do opt to replace a few planks of wood on your floor, be sure to determine the species (see above) before going down to wood floor refinishing mississauga the lumberyard.
Lagt till: 2018-02-04